|
| WWW.DBIT.CN 2007-12-25 8:22:03 热度： |
|
| |
dir List files on a filesystem
disable Turn off privileged commands
disconnect Disconnect an existing network connection
dot1x IEEE 802.1X Exec Commands
enable Turn on privileged commands
eou EAPoUDP
erase Erase a filesystem
exit Exit from the EXEC
format Format a filesystem
fsck Fsck a filesystem
help Description of the interactive help system
ip Global IP commands
lock Lock the terminal
login Log in as a particular user
logout Exit from the EXEC
mkdir Create new directory
monitor Monitoring different system events
more Display the contents of a file
name-connection Name an existing network connection
no Disable debugging functions
no Negate a command or set its defaults
ping Send echo messages
pwd Display current working directory
rcommand Run command on remote switch
reload Halt and perform a cold restart
remote Remote procedures
rename Rename a file
renew Renew
resume Resume an active network connection
rmdir Remove existing directory
rsh Execute a remote command
send Send a message to other tty lines
session Run command on member switch
set Set system parameter (not config)
setup Run the SETUP command facility
show Show running system information
systat Display information about terminal lines
telnet Open a telnet connection
terminal Set terminal line parameters
test Test subsystems, memory, and interfaces
traceroute Trace route to destination
tunnel Open a tunnel connection
udld UDLD protocol commands
undebug Disable debugging functions (see also 'debug')
upgrade Upgrade commands
verify Verify a file
vlan Configure VLAN parameters
vmps VMPS actions
vtp Configure global VTP state
where List active connections
write Write running configuration to memory, network, or terminal
其实还有几种模式如下：
全局配置模式：Switch(config)# 配置交换机的全局参数
接口配置模式：Switch(config-if)# 对交换机的接口进行配置，如某个接口属于那个Vlan，启用及禁用 接口等
线路配置模式：Switch(config-line)# 对控制台访问
VLAN数据库配置模式：Switch(Vlan)# 对Vlan的参数进行配置
再稍候我们来慢慢将解这些相应的模式下的作用与用法。
Cisco 交换机配置入门
机型：Cisco 3750
现在我们来继续讲解关于输入Cisco 命令时注意的一些事项与帮助
1.关于帮助
直接使用“?”，可以获得相应模式下的所支持的命令列表，如果再问号前面加上一些命令的开头的字母，就可以获得一些以此字母开头的命令，如：
AITG_FrontekCoreSW#s?
*s=show send session set setup
show systat
输入"S?"，就可以获得以S开头的所有字母。
2、命令帮助
如果对某个命令的用法不熟悉时，也可以使用“?”来获取其详细的帮助，如想对show的命令作一个具体的了解，可以使用：“show ?”
AITG_FrontekCoreSW#show ?
aaa Show AAA values
access-lists List access lists
accounting Accounting data for active sessions
adjacency Adjacent nodes
aliases Display alias commands
archive Archive functions
arp ARP table
auto Show Automation Template
auto Show Automation Template
boot show boot attributes
buffers Buffer pool statistics
cable-diagnostics Show Cable Diagnostics Results
cca CCA information
cdp CDP information
cef CEF address family independent status |
|
| |
|
|
|
|
|
|
|
|
